Propel Quality Measurement
| |
|
| * |
Model: CA-600
Features:
DC/AC Current Clamp transmitter
Model：CA-600
Features :
☆ Coverts any DMM to a current clamp
☆ Measure current without disconnecting circuit under test
☆ AC/DC 600A capability
☆ Dual Hall-effect sensors
☆ Accuracy DC:±2%+2A AC: ±3%+2A (50~400Hz)
☆ For use with any multi-meter at 200mV or 2V ranges for direct readout.
Input impedance at least 1MΩ
☆ Power on indicating
☆ Zero adjustment knob to compensate the hysteresis effect in
DC Measurements.)
☆ Transformer ratio:1000:1
☆ Output 1mV/A
☆ Jaw opening capability:30mm conductor
☆ Confirm to Safety:IEC 1010-1, IEC 1010-2-032,UL,CE approved.
☆ Low battery indication
-
Specifications :
Measurement range:
600A DC or AC
Accuracy:
± (2% reading +2A)
Frequency Response (AC):
50Hz to 400Hz
Input Resistance:
10kHz typical
Maximum Conductor Size:
1.1 " (30mm)
General:
Power Requirement:
9V battery
Dimensions
7x2.75x1.3(178x70x33mm)
Weight:
11 oz. (290g)
Accessories:
Battery, owners manual
CA-600 DC AC Currrent Clamp Transmitter
The length of the cable for both models, CA-60 and CA-600, is curled wire 2.63 Feet (80 cm ) and extension are able to 4.3 Foot( 130 cm ) approx.
- CA-06 Adapter (Option)
- BNC- Female 4mm Banana post adapter for receiving Signal output from CA-60 and able to be monitored by oscilloscope.
Use LF-180 and TL-19 together to connect CA-600 with any oscilloscope
to monitor low frequency signal.
| LF-180 BNC Probe- 4mm Male Banaba connector | TL-19 Female 4mm to Female 4mm socket for connecting 4mm Banana male Jack |
 |
 |
| TECPEL CO., LTD. E-MAIL
:
sales@tecpel.com
; oka@oka.com.tw
|
