E RT 580 INTRODUCTION:
DIGITAL EARTH RESISTANCE TESTER
The ERT 580 is a rofessional Instrument? The RUGGED and O-RING sealed digital is built with all the
protection you need for outdoor use. The ERT 580 is suitable for the testing of single earth electrodes
such as lightning conductors and other small earthing systems. The resistance of conductors such as
continuity and conductor coupling joints can also be measured. Two-terminal operation measurement,
which reduces the accuracy, can also be done by shorting P and C terminals.
Earth resistance can be measured directly from 0.01 ohms up to 1999 ohms. The reading is displayed
on a large, easy to read digital display.
The ERT 580 makes measurements by passing a constant current through the device under test
(generally a conductor or low resistance) and measuring the voltage across it. The earth resistance is
then calculated by Ohm's Law.
It has an advanced circuit design that permits the instrument to operate with the minimum influence from
earth voltage and earth resistance of the auxiliary spikes. This superb instrument is powered by 6 x 1.5
volt manganese-alkaline AA batteries. The calibration of the instrument is performed with the included
test leads. Therefore, when using the supplied test leads, the accuracy does not suffer of the three-
terminal method of measurement for the most common applications.

LED INDICATIONS:
LED If the constant current of the instrument has been reached and stable, the resistance between the
electrodes is within range and the reading can be valid.
The ERT 580 is supplied complete with an instruction manual.
The test frequency of 820Hz has been chosen to avoid stray currents at power frequencies and their
harmonics. However, the ERT 580 has a built-in filter to reject unwanted signals. The batteries are
constantly being checked while in use. The case is ideal for outdoor work. With the ERT 580 earth
electrode testing, which is an important part of electrical installation and maintenance procedure, is
made easy. The ERT 580 can be used by the electrical contractor or maintenance engineer to check the
effectiveness of their type of earth electrode systems. It may be used to test in accordance with Bs7671,
Bs7430, IEC364, NFC15-100, SABS0142, VDE0413, etc.

ERT 580 TECHNICAL SPECIFICATIONS
Steps of 0.01 Ohm
Earth Resistance Ranges Steps of 0.1 Ohm
Steps of 1 Ohm 0-19.99 Ohm
0-199.9 Ohm
0-1999 Ohm
Accuracy of earth resistance (of RDG) 1.5%-?dgt
Test Current (reversing DC) (820Hz?Hz) 2mA
AC voltage range (sine 40-60Hz) 0-199.9V
Accuracy (% of full scale) 1?1 dgt
Maximum output voltage (E-C) 0-30V
Battery (AA pen light) 6
ERT 580 High Performance Review:
PERFORMANCE SELECTION At a glance
Measures low earth resistance
Rejects interferences
Measures earth electrodes directly
Indicates if resistance of auxiliary spikes in within tolerance.
Over voltage protection
True constant current source
Allows 2 or 3-terminal testing (ext. Short)
Rugged and -Ring?sealed case
3-terminal measurement accuracy
Industrial grade case
Color coded test leads
Meets CE requirements & IEC 1010
LED indicator
Crowbars
Knob selection or ranges
Large digital display
6 x AA battery
Certificate: CE


Ordering information:
ERT-580 Earth Resistance Test er